A
B
C
D
E
I
F
H
G
J
DIGITAL DEPTH GAUGE
REF. GAUGE/60
Thank you for purchasing this Trend product which should give
lasting performance if used in accordance with these instructions.
INTENDED USE
This accessory is intended to be used to set the depth of cut
of a router cutter or saw blade. It can also be used to measure
hole depths up to 50.8mm deep. Do not install into high vibration
machines.
SAFETY
Read and understand the instruction sheet carefully
before using. This is a sensitive precision tool. Do not
disassemble or drop it. Please note the magnets in the
base. Store out of reach of children. Do not use as a toy
or as a weapon.
PLEASE KEEP THESE INSTRUCTIONS IN A
SAFE PLACE.
CONFORMITY DECLARATION
This product conforms with EMC Directive 2004/108/EC.
DESCRIPTION OF PARTS
A. Rule scale
B. Battery container
C. Locking screw
D. LCD display
E. Mm/inch/fraction button
F. On/off button
G. INC/ABS button
H. Depth pin park
I. Depth pin (shown fitted)
J. Base magnet
Mm/Inch/Fraction Button:
Short press mm/inch/fraction to convert between the three modes. Under
fraction mode, within 1/32” ±0.004” readout will convert the number after
radix point into fraction display.
Outside radix point the display will flash “in”.
INC/ABS Button:
Short press to convert between INC mode and ABS mode. Enter INC mode
at the same time to set ZERO (display will show “INC”), enter ABS mode
and the LCD will display “ABS”.
OPERATION
On/Off Button:
Short press ON/OFF to turn on, under ABS mode short press it to
set zero. Long press over 3 seconds to shut off.
Auto shut off function in 5 minutes.
Absolute Measuring (ABS)
Short press ON/OFF to turn on, short press INC/ABS to convert to ABS
mode (LCD will display ABS symbol). Short press ON/OFF to set to zero.
The measuring number is now absolute number.
Relative Measuring (INC)
The gauge can convert to INC mode at any position and at the same time
set to zero (display will show INC symbol). The measuring number is now
the relative number.
Depth Pin
The gauge has a depth pin that can be fitted onto the end of the rule to
measure hole depths. When not used the pin can be parked on the
housing tabs.
