Thank you for choosing the Vibra-Quatic 320
metal detector made by Treasure Products Inc.,
the originators of the vibrating pinpointer.
The unique sealed design allows detecting in any
environment including grass, mud, dirt, sand,
black sand, or even in fresh or salt water to a
depth of 100 feet (30 meters).
Pinpointer Metal Detector
Product Features
Communicates with vibration & light
When a target is located the Vibra-Quatic 320
signals with pulses of vibration and flashes of
bright light from a blue LED.
Pulse Induction Technology (PI)
A specialized type of detection technology that
allows hunting in salt water or in any type of soil,
including black sand.
Detection depth stability
Advanced electronic circuitry maintains detection
distance throughout the life of the battery.
Target distancing
As you get closer to the target the pulses of
vibration and light will increase in quantity
.
Automatic tuning
The state-of-the-art microprocessor controlled
design requires no adjustments of any kind.
Waterproof to 100 ft (30m)
The detectors sealed design allows hunting in the
rain or under water to a depth of 100 feet.
Battery Installation
Understanding the Compartment Seal
This detector uses a compression plug to seal the
battery compartment. When the knob of the seal
is rotated clockwise, the rubber in the plug
expands and presses against the inside wall of
the battery compartment, sealing the unit.
Opening battery compartment
To open the battery compartment seal, rotate the
knob counter-clockwise a few turns, then pull to
remove.
Connecting battery
Connect a standard 9-volt battery to the battery
clip and insert the battery into the detector, clip
side first.
Sealing the compartment
To replace the seal, insert all the way in. Then
turn the knob clockwise until hand tight to assure
a water-tight seal.
Before submerging detector make sure
the battery compartment seal is secure.
Operating Instructions
Power on
Hold unit with the search tip up. Light will flash. Two
short pulses of vibration, and a steady dim light,
indicate unit is on.
Power off
After use, hold unit with the search tip up. Light will
flash. Two long pulses of vibration, and no light,
indicate the unit is off.
Low battery auto-off
When the battery is low the unit will shut down
automatically indicated by four long pulses of
vibration and bright light.
Detecting a Target
The Vibra-Quatic communicates through pulses
of vibration and bright light. These pulses
increase in quantity the closer the search tip is to
a detected target.
The quantity of pulses is proportional to the target
size and distance. The bigger the target, or the
closer the probe tip is to the target, the higher the
pulse count.
You can either probe the soil or sweep the tip
side to side on the surface you are detecting. The
detector directs its detection field straight out the
tip. This allows you to precisely locate the target.
The Vibra-Quatic communicates its proximity to
the target only one time per detection. Move the
tip slightly away and then re-approach the target
to get the next detection.
Made in USA
Treasure Products Inc.
www.TreasureProducts.com
Vibra is a registered trademark of Treasure Products Inc.
Use only high quality batteries such as
alkaline or nickel metal hydride (NiMH).
320
Vibra-Quatic
Continued on back
