20
STEP E-10
The steering and throttle servos are not included with the kit. Follow your
radio system’s instructions for “centering” the servos before installing any
servos. Attach the steering servo to the upper chassis plate, exactly as shown,
with four 3x8mm washerhead self-tapping screws.
STEP E-9
Locate two 3mm flat washers and two 3x30mm hex cap screws (shown
below). Place the washers over the shoulder screws and secure the bellcrank
assembly to the posts.
STEP E-8
Slide the bellcrank assembly over the posts as shown (note photo for exact
assembly).
STEP E-11
Locate the servo saver and adapters, the 28mm threaded rod, two long rod
ends, two hollow ball connectors, one 3x15mm washerhead machine screw,
one 3x12mm washerhead machine screw and one 3mm locknut.
STEP E-12
Screw the rod ends onto the threaded rod, an equal number of turns each, so
that there is a center-to-center distance of 46mm. Snap the two hollow ball
connectors in to the holes on the rod ends. This assembly will now be
referred to as the steering rod.
Servo Saver
Adapters
46mm
