10
STEP A-31
Fasten the motor to the transmission with the two 3x8mm
washerhead machine screws. Do not tighten the screws yet.
STEP A-32
Slide the pinion gear (teeth first) onto the motor shaft as shown.
Insert the grub screw into the pinion gear and tighten it against the
flat of the motor shaft with a 1.5mm Allen wrench.
INSTALLING THE GEAR COVER:
STEP A-34
Locate the gear cover and two 3x5mm roundhead machine screws. Snap the
gear cover over the spur gear and secure it with the two 3x5mm roundhead
machine screws.
INSTALLING REAR CAMBER LINKS:
STEP A-35
Locate the rear shock tower, two 90mm camber links, two 3x12x4mm
shoulder screws (the 4mm dimension refers to the length of the shoulder),
two 3x12mm roundhead self-tapping screws, and two 3mm flat metal
washers. The shoulder screws are located in bag H.
BANDIT:
The rear camber links are 65mm overall length.
STEP A-33
Slide the motor forward so that the pinion gear meshes with the spur gear.
Adjust the gear mesh by inserting a piece of thin note paper into the gear
mesh and then tightening the motor screws. When the paper is removed,
there should be a slight amount of play between the spur gear and the
pinion gear.
Shoulder screw
