2
7.
Turning anti-clockwise #48(Safety Cap Nut) for loosening rivet nut.
Maintenance
When adjusting adaptor cover (#5) to the Max. stroke(10mm) without action after pressing trigger. It might be empty of Hydraulic Oil. Please
follow below steps to refill Hydraulic Oil.
1.
Disconnect from air supply
2.
Using spanner to remove cylinder cap #35 as in Fig. 1
3.
Removing the piston assembly using pliers as in Fig.2
4.
Fill with hydraulic oil, Viscosity ISO: VG46 as in Fig.3
5.
Use silicone grease on wall of cylinder and piston as in Fig.4
6.
Reassemble in reverse process.
Maintenance for Nut Riveter Head
1.
Using spanner to remove Connector Housing #6
2.
Using spanners to take apart the inner housing parts
3.
loosening all parts
4.
Lubricate the 1A
～
1F Screw Mandrel and piston with silicone
grease.
5.
Reassemble in reverse process.
Mandrel Replacement
1.
Connecting air supply then pressing trigger and removing #3,
#2 and #5 parts as in Fig.5.
2.
Disconnecting air supply then use spanner to luck #4 parts
and loosen the #1 mandrel as in Fig 6.
3.
Using spanner to luck #4 parts and screw up the new or
another size #1 mandrel as in Fig.7.
4.
Connecting air then pressing trigger and reassemble #3, #2,#5
parts.
5.
Adjusting the gap of #5 between #6 around 1.5~2.0mm as in
Fig.8.
Fig.1
Fig.2
Fig.3
Fig.4
Fig.5
Fig.6
Fig.7
Fig.8
*
Turning Anti-clockwise
#48(Safety Cap Nut) for
loosening rivet nut.
Loosen mandrel
Screw up
mandrel
1.5~2.0mm
