24
Finalizing the Installation
© Travis Industries
4120309
100-01287_000
Steps for Finalizing the Installation
1. Remove the glass (see page 22).
NOTE:
If using propane (LP) convert the appliance prior to installing the logs.
2. We recommend you purge the gas line at this time (with the glass removed). This allows gas to be
detected once it enters the firebox, ensuring gas does not build up.
3. Make sure the accent light bulb is in place.
NOTE
: Take care to not touch the bulb with your fingers – use a cloth or paper towel).
4. Install the four AA batteries and receiver cover (included in the owner’s pack - see illustration below).
The AA batteries act as a power backup in case the household (AC) power goes out and are required
for operation. Install the 9v battery (included in the owner’s pack) into the battery holder (see
illustration below). This battery is for the control panel lights. Install three AAA batteries into the
remote (see illustration below). Synchronize the transmitter to the receiver (see page 26).
9v
Battery
Battery Holder for
Control Panel Lights
°F
AAA Battery
AAA Battery
AAA Battery
AA Battery
AA Battery
AA Battery
AA Battery
The remote receiver
uses 4 AA batteries.
The remote
uses 3 AAA
batteries.
CONTINUOUS
PILOT
GREEN SMART
PILOT
ON
REMOTE
OFF
PRG
ACCENT LIGHT
BLOWER
OFF
HIGH
LOW
OFF
HIGH
LOW