Filter Accessory Kit Instructions, Ring of Fire
(SKU 93007326)
Page 1 of 6
Printed 8/4/04
© Travis Industries, Inc.
Compatibility
This accessory kit is designed for the Ring of Fire fountains using propane (LP) that are encountering soot in
the water (the water turns black over time). Please contact Travis Industries if you have any questions
regarding this kit and to its use.
The filter is installed between the water pump and fountain heads, filtering the water while the fountain
operates. Our research has shown this filter to last approximately 35 hours of burn time per filter.
Packing List
•
10” Filter Housing (with ½” tube fittings attached) and Filter
•
(2) ½” MPT to ½” Barbed Tube Fittings (PVC) with Conduit Lock Nuts Attached
•
(2) ½” FPT to ½” Barbed Tube Fittings (PVC)
•
(2) ½” Neoprene Gaskets
•
(3) 30” Sections of ½” Tubing, (1) 2
0
” Section of ½” Tubing
•
(6) Hose Clamps
•
(4) 4” Lock Ties
Items Needed for Installation
• Drill with 7/8” drill bit (hole saw or step-up bit)
• Adjustable Wrenchs (or vice grips)
• Teflon Tape (or paste)
• ¼” Nutdriver (or Flat Head Screwdriver)
Important Warnings
•
Turn off gas and electricity to the fountain prior to conducting service.
•
If the fountain is in a location where it may freeze, drain the filter of water when you “winterize” your
fountain.
Installation
1. Gain access to the underside of the fountain (this may require removal of the fountain from the pedestal). Make
sure the fountain is secure before proceeding.
2. Remove the spray head, inner screen and outer screen from the top of the fountain. Remove the water from
the fountain tank. Remove and discard the tube that runs from the water pump to the spray ring.
Remove and discard this
tube.
