Transition Networks
PS-DC-DUAL-5624T Power Supply Install Guide
33788 Rev. D
Page
10
of
18
2. Installation
Cautions and Warnings
Cautions and Warnings appear here and may appear throughout this manual where appropriate. Failure to read and
understand the information identified by this symbol could result in poor equipment performance, damage to the
equipment, or injury to persons.
Cautions indicate that there is the possibility of poor equipment performance or potential damage to the equipment.
Warnings indicate that there is the possibility of injury to person.
See
Electrical Safety Warnings
on page
16
for Electrical Safety Warnings translated into multiple languages.
High Risk Activities Disclaimer
: Components, units, or third-party products used in the product described herein are
NOT fault-tolerant and are NOT designed, manufactured, or intended for use as on-line control equipment in the
following hazardous environments requiring fail-safe controls: the operation of Nuclear Facilities, Aircraft Navigation or
Aircraft Communication Systems, Air Traffic Control, Life Support, or Weapons Systems ("High Risk Activities").
Transition Networks and its supplier(s) specifically disclaim any expressed or implied warranty of fitness for such High
Risk Activities.
Notice
: Not Designed for Use in Life Support Equipment or Applications: These products are not designed for use in life
support equipment or applications that would cause a life-threatening situation if any such product failed. Do not use
this product in these types of equipment or applications.
Operating Temperature - RESTRICTED ACCESS LOCATION
: A location for equipment where both of the following
paragraphs apply:
–
access can only be gained by SERVICE PERSONS or by USERS who have been instructed about the reasons for the
restriction applied to the location and about any precautions that shall be taken; and
–
access is through the use of a TOOL or lock and key, or other means of security, and is controlled by the authority
responsible for the location.
NOTE
: The requirements for equipment intended for installation in RESTRICTED ACCESS LOCATIONS are the same as for
OPERATOR ACCESS AREAS, except as given in 1.7.17, 2.1.3 and 4.5.1.
1.2.7.4 TOOL: A screwdriver or any other object which may be used to operate a screw, latch or similar fixing means.
1.2.7.5 BODY: All accessible conducive parts, shafts of handles, knobs, grips and the like, and metal foil in contact with all
accessible surfaces of insulating material.
1.2.7.6 SAFETY INTERLOCK: A means either of preventing access to a hazardous area until the hazard is removed, or of
automatically removing the hazardous condition when access is gained.
WARNING
HOT SURFACE
DO NOT
TOUCH
