Transas T214, Техническое руководство

Страница: 59 / 115

Setup of serial ports parameters
Chapter 6. Commissioning.Internal configuration
57
Chan. Load (last) – Previous frame channel load (note2);
Bad CRCR cntr – Number of (messages with bad CRC) (note2);
Chan. Load (forecast) – Forecast channel load (note2);
Noise level – Average noise level (note2);
RSSI (frame) – Received signal strength (note2);
VDM/VSI out – Provide VSI sentence with each VDM sentence (note3);
VDO/VSI out
– Provide VSI sentence with each VDO sentence (note3);
FSR out – Provide FSR sentence after each frame (note3).
Notes:
1.
0 = no output
1 = continuous output
2 = output next frame only
2. 0 = no output
1 = output once per frame
2 = output next frame only
3. 0 = off, disabled
1 = on, enabled
6.5
SETUP OF SERIAL PORTS PARAMETERS
When external devices are connected to the serial ports, it is necessary to make
settings of the port status, baud rate, parity and the stop bit number. This is done in
the Configuration->Setup->Serial port setup menu.
Standard port settings:
Port name St. Parameters Notes
Sensor 1 Off - Please don’t change
Sensor 2 (external
Sensor port) On 4800, N, One
Sensor 3 Off - Please don’t change
Int.GNS On 4800, N, One Please don’t change
Main (internal) On 38400, N, One Internal port. Please don’t
change, refer to 5.1
Aux (internal) On 38400, N, One
Internal port. Please don’t
change, refer to 5.1