Epic 3000
Programmer’s Guide
Programming Codes
100-14362
Rev A
Page 155
Aztec Print Options
Function
Aztec code control
ASCII
[ESC] [EM] a <f> <v>
Hexadecimal
1BH 19H 61H <f> <v>
Decimal
<27> <25> <97><f> <v>
IPCL
None
Description
This command alters the way Aztec barcodes are generated and printed.
Where
f = Feature to control and v = the value of the feature.
f = W 57H, 87D
Set the minimum element width.
v = 1-10, 6 is the default and height.
A width of 1 may be unreadable.
It the barcode will not fit in the print zone, the printer will
automatically reduce the width until the barcode will fit. If
the barcode will not fit at a width of 1, the printer will not
print the barcode.
f = M, 4DH, 77D
QRCode Matrix Size. 1-36 are accepted. 0
– Auto
Size 1-4 are Compact and 5-36 are normal.
f = E, 45H, 69D
QRCode Error Correction.
1-4 are accepted. 0 = default to level 2
f = H, 48H, 72D
Blank Space between the barcode and the following data
Default 8
f = G, 47H, 71D)
GS1 Mode. (See General description above)
If in GS1 mode the symbol start with an FNC1 and that the
compression is slightly altered. GS1 data formatting and
compaction are active and the input must follow the GS1
rules.
f = P, 50H, 80D
HRI Position
f =0
– Off, f = 1 - Top, f =2 - Bottom, f =3 - Both
f = F, 46H, 70D
HRI Font
f = 0 Medium, f=1 Larger, f- 2 Smaller (Note: Fonts may be
redefined by using the change legacy font command.)
Содержание Epic 3000
Страница 1: ...Epic 3000 Programmer s Guide PN 100 14362 Rev A Dec 2015...
Страница 2: ...Programming Codes Epic 3000 Programmer s Guide Page 2 Rev A 100 14362...
Страница 266: ......