6
SSP-SVX001D-EN
General Information
This manual describes proper installation, operation,
and maintenance procedures for air-cooled systems.
By carefully reviewing the information within this
manual and following the instructions, the risk of
improper operation and/or component damage will be
minimized. It is important that periodic maintenance be
performed to help assure trouble free operation.
Should equipment failure occur, contact a qualified
service organization with qualified, experienced HVAC
technicians to properly diagnose and repair this
equipment.
IIm
mp
po
orrtta
an
ntt:: All phases of this installation must comply
with the NATIONAL, STATE & LOCAL
CODES. In addition to local codes, the
installation must conform with National
Electric Code -ANSI/NFPA NO. 70 LATEST
REVISION.
Any individual installing, maintaining, or servicing this
equipment must be properly trained, licensed and
qualified.
IIm
mp
po
orrtta
an
ntt:: Do not remove the VFD without first
contacting technical support! For
performance-related questions and
diagnostic support in North America call 1-
877-872-6363. Any return requires a claim
number FIRST. Removal of the VFD prior to
this step will void the unit’s warranties.
Installation procedures should be performed in the
sequence that they appear in this manual. Do not
destroy or remove the manual from the unit. The
manual should remain weather-protected with the unit
until all installation procedures are complete.
N
No
otte
e:: It is not the intention of this manual to cover all
possible variations in systems that may occur or
to provide comprehensive information
concerning every possible contingency that may
be encountered during an installation. If
additional information is required or if specific
problems arise that are not fully discussed in this
manual, contact your local sales office.
Use the
“Installation Checklist,” p. 8
provided in this
manual to verify that all necessary installation
procedures have been completed. Do not use the
checklist as a substitute for reading the information
contained in this manual. Read this entire manual
before beginning installation procedures.
Unit Description
These condensers come with single and dual
compressor options. Single compressor outdoor units
feature a single refrigeration circuit requiring only one
set of refrigerant lines. Dual compressor/dual circuit
models give true stand-by protection; if one
compressor fails, the second will automatically start-
up. During light load conditions, only one compressor
will operate to save energy.
