Trane Power Exhaust Foundation BAYPWRX320, Руководство по установке

Страница: 5 / 16

ACC-SVN199E-EN 5
General Information
Power Exhaust is designed for downflow applications. For
horizontal applications, the Power Exhaust may be
mounted on the horizontal return duct. However, it is the
installer's responsibility to determine how to complete
such installation. An economizer must be installed and
functional before installing the Power Exhaust.
Inspection
1. Unpack all components of the kit.
2. Check carefully for any shipping damage. If any
damage is found it must be reported immediately and
a claim made against the transportation company.
3. Visually inspect the components for shipping damage
as soon as possible after delivery, before it is stored.
Concealed damage must be reported within 15 days.
4. If concealed damage is discovered, stop unpacking the
shipment.
5. Do not remove damaged material from the receiving
location. Take photos of the damage, if possible. The
owner must provide reasonable evidence that the
damage did not occur after delivery.
6. Notify the carrier’s terminal of damage immediately by
phone and by mail. Request an immediate joint
inspection of the damage by the carrier and the
consignee.
Note: Do not attempt to repair any damaged parts until
the parts are inspected by the carrier’s
representative.
Parts List
Field Supplied Part
1 - Tube Sealant - Trane recommends Sikaflex 221
(SEL00439)
Figure 1. Major power exhaust components
Table 1. Major power exhaust components
Item Item Description Qty
9 Power Exhaust assembly 1
3 Internal block-off, left 1
1 Internal block-off, Right 1
8 Power exhaust alignment bracket 1
2 Internal block-off, Center 1
6 Bushing 0.81" ID 1
11 Tape 2" aluminum 3
10 Label 1
4 and 5 Gasket 1
12 Top block off assembly 1
7 Gasket roll
13 Low leak Economizer harness 1
NOTICE
Corrosion Damage!
Use of non-recommended caulking/sealant could cause
corrosion related failures to refrigeration components.
9
Label
12
13
7
4
5
11
10
6
2
8
1
3
Installation Bag
with Screws