8
MS-SVN15B-EN
Indoor Unit
1.
Select a location to route tubing, wiring and drain pipe between the indoor and outdoor units.
2.
Make a hole in the wall using a key hole saw or hole-cutting drill attachment.
The hole should be made at a slight downward slant to the outdoor side (Figure 5).
Before cutting, check that no pipes or studs are directly behind the place to be cut. Avoid
areas where electrical wiring or conduits are located.
3.
Place the unit on a solid and level foundation.
4.
Tubing, wiring through and drain pipe of low wall and floor mounted units can be routed,
rear or right side of unit when facing front. Ceiling mounted can be routed straight
downward.
5.
Pull air filters upward (Figure 6).
6.
Unscrew at the return grille (Figure 7).
Unit installation
Figure 1.
Figure 2.
Figure 3.
Indoor side
Outdoor side
Pull
Pull
