Trane MCW509AMUA0, Руководство пользователя

Страница: 10 / 23

10
Remote
controller
holder
Set.
Receiver
+
–
–
+
2
3
1
Position + and
– correctly!
About batteries
●
When replacing the batteries, use
batteries of the same type, and replace
the two old batteries together.
●
When the system is not used for a long
time, take the batteries out. In case the
remote controller is not used for a long
time remove all batteries in order to
prevent liquid leak of the battery.
●
When the operation display screen of the
remote controller is hard to see and the
reception become hard, replace the
batteries with new AAA batteries.
●
The attached batteries are provided for the
initial use of the system.
The usable period of the batteries may be
short depending on the manufactured date
of the air conditioner.
●
Pressing two or more buttons
simultaneously may cause the strange
display of the Remote controller.
The Remote controller is not malfunction.
In this case take the batteries out and
reset them.
Remote controller
Press with a finger and slide the front
cover to take it off.
Set two dry batteries (AAA).
Set the front cover as before.
●
This will cause the figures on the display
to flash. Set the clock at this point.
1
2
3
■ ■ ■ ■ ■
Operating the remote controller
●
To use the remote controller, aim the transmitter at
the indoor unit. If there is anything to block signals
between the unit and the remote controller, such as
a curtain, the unit will not operate.
●
Do not drop the remote controller. Do not get it wet.
●
The maximum distance for communication is about
23 ft.
●
To remove, pull it upwards.
■ ■ ■ ■ ■
To fix the remote controller
holder on the wall
Choose a place from where the signals reach
the unit.
Fix the holder to a wall, a pillar, etc. with the
screws supplied with the holder.
Place the remote controller in the remote
controller holder.
1
2
3
■ ■
■ ■
■
Setting the batteries
ATTENTION
ATTENTION
About the remote controller
●
Do not put the remote controller in the
following places.
•
In direct sunlight.
•
In vicinity of a heater.
●
Dust on the signal transmitter or receiver
will reduce the sensitivity. Wipe off dust
with soft cloth.
●
Signal communication may be disabled if
an electronic-starter-type fluorescent lamp
(such as inverter-type lamps) is in the
room. Consult the dealer if that is the case.
●
If the remote control signals happen to
operate another appliance, move that
appliance to somewhere else, or consult
the dealer.
Preparation Before Operation
01̲EN̲3P102561-6F.p65
03/06/04, 9:22 Page 10
Adobe PageMaker 6.5J/Win