Trane Foundation GBC Series, Инструкция по установке, эксплуатации и обслуживанию

Страница: 16 / 40

16 RT-SVX069A-EN
☐ Verify that the installation location of the unit will
provide the required clearance for proper
operation.
☐ Assemble and install the roof curb (if applicable).
Refer to the latest edition of the curb installers
guide that ships with each curb kit.
☐ Fabricate and install ductwork; secure ductwork to
curb.
☐ Rigging the unit.
☐
Set the unit onto the curb; check for levelness.
☐ Ensure unit-to-curb seal is tight and without buckles
or cracks.
☐ Install and connect a condensate drain line to the
evaporator drain connection.
Main Electrical Power Requirements
☐
Verify that the power supply complies with the unit
nameplate specifications.
☐ Inspect all control panel components; tighten any
loose connections.
☐ Connect properly sized and protected power supply
wiring to a field-supplied/ installed disconnect
switch and to the main power terminal block in the
unit control panel.
☐ Install proper grounding wires to an earth ground.
N No otte e:: All field-installed wiring must comply with NEC
and applicable local codes.
External Vent Hood Installation
W WA AR RN NIIN NG G
H Ha azza arrd do ou uss V Vo olltta ag ge e!!
F Fa aiillu urre e tto o d diisscco on nn ne ecctt p po ow we err b be effo orre e sse errv viicciin ng g cco ou ulld d
rre essu ulltt iin n d de ea atth h o orr sse erriio ou uss iin njju urry y..
D Diisscco on nn ne ecctt a allll e elle eccttrriicc p po ow we err,, iin nccllu ud diin ng g rre em mo otte e
d diisscco on nn ne eccttss b be effo orre e sse errv viicciin ng g.. F Fo ollllo ow w p prro op pe err
llo occkko ou utt//tta ag go ou utt p prro occe ed du urre ess tto o e en nssu urre e tth he e p po ow we err
cca an n n no ott b be e iin na ad dv ve errtte en nttlly y e en ne errg giizze ed d.. V Ve erriiffy y tth ha att n no o
p po ow we err iiss p prre esse en ntt w wiitth h a a v vo ollttm me ette err..
1. Remove and discard the cover plate located on the
gas heat panel.
IIm mp po orrtta an ntt::
• Make sure you read the label
located on the cover plate before
you discard it.
• Do not discard the fastening screws!
They will be needed to install the
vent hood.
Figure 10. Discard cover plate
2. Locate the vent hood behind the panel, along the
base of the unit.
3. Install the vent hood on the gas heat panel using
the screws removed in Step 1. Make sure it is
properly secured to the panel.
Figure 11. Vent hood installation
Condensate Drain Configuration
An evaporator condensate drain connection is
provided on each unit. Refer to
“Unit Weights,” p. 13
for the appropriate drain location.
N No otte e:: Use 1-inch PVC pipe to connect to the drain pan
outlet provided in the unit. This is a slip fit joint
(no threads) and can be sealed using PVC
Cement or other suitable adhesive.
IIn nsstta alllla attiio on n