Process view button row ver. 2
5.7 Control settings
Control settings
The
Control settings
view allows you to toggle between different modes and specify
setpoints. The view can be accessed from the
Process
view. An active selection is
indicated in green.
To change a setpoint, tap on the setpoint value.
Pos.
Item
Description
1
Start difference and stop
difference
These values specify how much the temperature must
exceed or fall below the setpoint before the unit will be
started or stopped (for example, when heating is no longer
required). The unit will be stopped with a delay.
2
Primary control mode selection
Switch between two modes:
Chill
(snowflake button) or
Heat
(sun button).
3
Setpoint control method
Select the method with which the setpoint is determined
(see the table below).
48 (66)
EXES01 2150EN
