16
48663983 Rev 1
Contents
2.4.1. Range of Operation
2.4.1.1. Lock and Indoor Unit range
Range (Indoor)
Range (Outdoor - without any obstacles)
15 meter
1000 meter
2.4.1.2. Remote and Indoor Unit range
Range (Indoor)
Range (Outdoor - without any obstacles)
14 meter
160 to 175 meter
2.4.2. Functions
2.4.2.1. TRANE Mode
1. Press to start or stop TRANE mode (Refer Figure - 7).
2. The unit when powered ON by remote control starts with TRANE mode by default.
3. The TRANE mode will set room temperature and fan speed automatically to provide
an energy e
ffi
cient and comfortable environment hence the energy e
ffi
ciency
meter always shows dark green (Refer Figure - 5)
4. It will set room temperature automatically based on outdoor temperature.
5. Unit shall exit ‘TRANE mode’ if user changes any of the following: set point, fan speed, mode, sleep and
also if button is pressed.
6. Unit will not exit ‘TRANE mode’ if user changes any of the following:
swing button,
multi room or
night latch button.
7. The indication of TRANE mode is button with red back light and the remaining buttons with light
OFF. The back light will go OFF after 20 seconds from last operation of remote controller.
2.4.2.2. Cool Mode
Figure - 8
COOL
DRY
FAN
e
1
2
3
Display
1. Press MODE to select cool mode, see ‘COOL’ shown on display (Refer Figure - 8).
2. Press to set fan speed (if required)
3. Press
or
to increase or decrease set temp. Set temperature range is 17°C - 30°C.
This is normal mode of cooling. User can set room temperature and AC will run to
attain the set temperature.
Temperature can be set based on energy consumption, Refer below table
Zone 1 - Red
Uneconomical
Zone 2 - Yellow
Higher energy consumption
Zone 3 - Light green
Economical
Zone 4 - Dark green
Lower energy consumption
Figure - 7
e
Figure - 9
1
2
3
4
