Trane CCE-Compact Series, Установка, эксплуатация и обслуживание, Страница: 98 / 115

98/115 V07-19.0
Parameter Value Description
General: Module configuration/info
Software version Display software version
Device ID Display device ID
Module Display module information
Use default Active Set back to the default settings
Table 40: LON configuration
22.2.5 Modbus RTU/ IP controller interfaces
Directly on controller there are 2 communication ports available (1 for IP and 1 for RTU). The IP in-
terface you can use for Web-Application (within your network), where you can monitor the same sit-
uation like on the local HMI display.
Modbus RTU (on board) has no galvanic isolation and is just to use for building management; if
power measurement will be done over IP, connection to BMS is not possible!
The configuration is carried out in the menu
Configuration Communication controller .
Parameter Value Description
IP-Config: (TCP-Port: 502)
IP Display IP address of controller
Mask Display subnet mask
Gateway Display gateway address
DHCP Display DHCP status (automatic reference of IP address from a DHCP
server)
Name Controller name
MAC Display MAC address
Change settings Submenu IP configuration
IP Config of IP address of controller
Mask Config of subnet mask (controller)
Gateway Config of gateway address (controller)
DHCP Config DHCP [Active]
Passive Manual address config
Active Automatic address config by DHCP server
100 Mbit Switch-over interface speed 10/100Mbps [Active]
Passive Speed 10Mbps
Active Speed 100Mbps
Link Activate IP interface [Active]
Passive Interface deactivated (no communication)
Active Interface activated
User name User name for WebVisu