ACC-SVN44D-EN
9
Installation
Factory Installed Economizer Set-Up
Downflow Configuration
To position economizer for Downflow operation, complete the following steps:
WARNING
Hazardous Voltage!
Disconnect all electric power, including remote disconnects before servicing. Follow proper
lockout/tagout procedures to ensure the power can not be inadvertently energized. Failure to
disconnect power before servicing could result in death or serious injury.
1.
Remove filter access panel.
2. Remove bottom blockoff from its shipping location. See
.
3. Remove the bottom three screws from the economizer panel.
4. Pull the economizer assembly out into operating position as shown in
5. Secure the economizer assembly with 2 screws at the bottom of the corner posts.
6. Install bottom blockoff and secure with 3 screws.
Figure 9.
Figure 10.
