BAS-SVX40K-EN
35
WCS-SB/SD Installation
A WCI, in addition to providing wireless communications between controllers, can provide wireless
communication to Air-Fi® Wireless Communications Sensors (WCSs). A WCI can receive the signal of
a WCS when the WCS has been powered up and addresses have been set up on it. Use the following
procedures.
Powering the WCS
Complete the following steps to power up the WCS:
1. Remove the WCS cover by firmly pressing the thumb tab at the bottom of the cover and pulling the
cover away from the back plate.
2. Power the sensor by removing the insulation strip from between the two batteries.
Figure 22.
Pulling the insulation strip from between batteries
WCS Addressing
Prior to setting addresses on the WCS, you need to know the group and network address (2 digits), the
network address (2 digits), and the unit controller address (3 digits).
Notes:
•
A Tracer SC group refers to all of the networks that communicate with the same Tracer SC.
•
Unit controller addresses above 127 may be used for Air-Fi Wireless systems. (Previously,
with hardwired MS/TP communication, no addresses higher than 127 were allowed.)
1.
Remove the cover of the sensor.
