6
HDWA-SVX001D-EN
Unit Nameplate
The unit nameplate is located on the right side of the
control panel. A typical unit nameplate is illustrated in
the following figure and contains the following
information:
•
Unit model and size descriptor
•
Unit serial number
•
Unit electrical requirements
•
Correct operating charge and refrigerant type
•
Unit test pressures and maximum operating
pressures
•
Unit literature
•
Drawing numbers for unit wiring diagrams
S
Se
erriia
all N
Nu
um
mb
be
err.. The unit serial number provides the
specific chiller identity. Always provide this serial
number when calling for service or during parts
identification.
S
Se
errv
viicce
e M
Mo
od
de
ell N
Nu
um
mb
be
err.. The service model represents
the unit as built for service purposes. It identifies the
selections of variable unit features required when
ordering replacements parts or requesting service.
N
No
otte
e:: Unit-mounted Adaptive Frequency
™
Drives
(AFDs) are identified by a separate number; refer
to
“Model Number Descriptions,” p. 8
P
Prro
od
du
ucctt D
De
essccrriip
pttiio
on
n B
Bllo
occkk.. The Agility
™
chiller
models are defined and built using the Product
Definition and Selection (PDS) system. This system
describes the product offerings using a product coding
block which is made up of feature categories and codes
that identify all characteristics of a unit.
Figure 1. Typical unit nameplate
