Trane ADAMO MCW 5097BA00, Руководство по установке

Страница: 7 / 16

MS-SVN003-EN
7
Figure 10
Drain hose
Wall hole
pipe
Pipe
Connection
cable
Figure 7
Connection
cable
Drain hose
Decorative tape
Left piping
Left rear piping
Bottom piping
Right piping
Cut the piping groove
with a hacksaw
Cut the piping groove
with a hacksaw
(Rear)
Indoor unit
piping
For left outlet, house the connection cord
and piping at the position shown in the above
figure with the drain hose at the bottom.
Figure 11
4. Install the piping so that the drain
hose is at the bottom (Figure 7).
Caution
• To prevent breaking of the pipe,
avoid sharp bends. Bend the
pipe with a radius of curveture of
100 mm. or more.
• If the pipe is bent repeatedly at the
same place, it will break.
• Do not remove the flare nuts
from the indoor unit pipe until
immediately before connecting
the outdoor connection piping.
5. After passing the indoor piping
and drain hose through the wall
hole, hang the indoor unit on the
hooks at the top and bottom of
the wall bracket.
6. Check to insure that: (Ref.
Figure 10).
• The top and bottom hooks are
hooked firmly and the indoor unit
does not move to the front and
rear or left and right.
• The indoor unit is accurately
positioned horizontally and
vertically.
• The drain hose is at the bottom
of the wall hole pipe.
Indoor Unit Wiring
Both of the cable wires should be
connect from the terminal block
of indoor unit (Figure 11).
• The appliance shall be installed in
accordance with national wiring
regulation.
• Means for disconnection from the
supply having a contact separation
of at least 3 mm. in all poles must
be incorporated in the field wiring.
Figure 9
After hooking the indoor unit to the top
hook, hook the fitting of the indoor unit to
the two bottom hooks while lowering the
unit and pushing it against the wall.
Wall hook
bracket
Indoor unit
(Rear)
(Fitting)
Bottom hooks
Top
hooks
Figure 8
Drain hose
(bottom)
Bind with
vinyl tape
Pipe (top)
(Rear)