Trane ADAMO MCW 5097BA00, Руководство по установке

Страница: 11 / 16

MS-SVN003-EN
11
Figure 23
Pipe
Clamp
Wall
Outside wall
cap sealer
(Outdoor)
End in water
Figure 24
Check the following:
Drain hose
Clamp
Lifted up
Wave
Finishing
1. Securely wrap the connection
cable along the refrigerant pipes
with vinyl tape. (Starting at the
lowest end of the pipes, each
wrap should be about 1/3 of the
tape width so that water does
not enter).(Figure 22)
2. Fasten the cable/piping to the
outside wall with clamps, etc.
3. Fill the gap between the outside
wall cap and the pipe with sealer
so that rain water and wind cannot
blow in.
4. Fasten the drain hose to the outside
wall, etc (Figure 23 & Figure 24).
Run Test
1. Start the system and check items 1
through 7 below.
2. For the system start procedure,
refer to the Owner Manual.
Indoor Unit
1. Is operation of the on and off button
and fan button normal?
2. Does each indicator on the remote
control display panel light normally?
3. Does the air deflection louver
operate normally?
4. Is the condensate drain normal and
freely flowing water?
Outdoor Unit
5. Is there any abnormal noise and
vibration during operation?
6. Will noise, air flow, or drain water
from the unit disturb the neighbors?
7. Is there any refrigerant gas
leakage?
Customer Guidance
Explain the following to the customer
in accordance with the Owner Manual.
1. Starting and stopping procedures,
mode switching, temperature
adjustment, timer and air flow
adjustment, and other remote
control operations.
2. Filter removal and cleaning and
how to use the air louvers.
3. Give the operating and installation
manuals to the customer.
Front Panel Assemble
Removal and Replacement
1. Removal
Side out the plastic screw cap (3
pieces as shown in the picture.)
Remove the front panel screws (3
pieces.)
Remove the horizontal vane to the
position as shown in the picture.
Open the front panel by lifting the
lower side of the panel carefully
2. Replacement
After securing the front panel tabs
into the holes in the body, fasten
the bottom of the front panel with
the three screws removed in step 1.
Front panel
Mounting screw
Horizontal vane
Figure 25