9
Remote Control Operation
Name and function of wireless remote control
ON/OFF
B
utton
Remote control
Signal transmitter
AUTO
COOL
DRY
FAN
(
O
nly for cooling and heating unit
.
)
Don't drop or throw the remote control
.
Don't let any liquid in the remote control
or
Note: Be sure that there are no obstructions between receiver and remote
controller
;
put the remote control directly under the sunlight or any place where is very hot.
ƽ
Press this button
to switch between modes
(Auto,Cool,Dry,Fan and Heat) as shown below.
MODE
B
utton
MODE
Auto mode is default while power on.
Under Auto mode,the temperature will not
be displayed; Under Heat mode, the
ƽ
Press this button, Sleep On and Sleep
Off can be selected. After powered on,
SLEEP
B
utton
SLEEP
Sleep
Off is defaulted. After the unit is
turned off, the Sleep function is canceled.
After Sleep function set up, the signal of
Sleep will display. In this mode, the time of
timer can be adjusted. Under Fan and Auto
modes, this function is not available.
ƽ
FAN
B
utton
FAN
CLOCK
B
utton
CLOCK
ƽ
Use this button to set up and select
temperature options: temperature setting
TEMP
B
utton
TEMP
(displays the room temperature selected),
indoor ambient temperature (actual room
temperature).
ƽ
Press this button, the unit will be turned on,
press it once more, the unit will be turned
off. When turning on or turning off the unit,
the Timer, Sleep function will be canceled,
HEAT
initial value is 28
ć
;Under other
modes, the initial value is 25
ć
R
)
82
R
)
77
Middle fan
Low fan
High fan
but the clock time will be saved.
ƽ
Press this button
to set up the clock time.
Once the
signal and display
begin to
blink
, the
time
can be adjusted by
pressing
MS-SVU42A-EN
Press this button to choose between Auto,
Low, Middle, or High speed. Auto fan speed
is default on power up. Under Blow mode,
Low fan speed only can be set up.
+ or - button. (Press + or - button continuously
to change timing value quickly),the setting time
range is from 0.5 to 24 hr.;press this key once
again to fix the time,then remote controller will
send out the signal immediately and hour on/offI
will stop flickering.If no button is pushed for 5
seconds while the display is still flashing, the
timer setting will not be saved. Press the clock
button once to exit the timer setting.
