Trane Technologies X1316105702, Инструкция по установке, эксплуатации и обслуживанию

Страница: 31 / 48

BAS-SVX10F-EN 31
Operation
Changing System Settings
Indicates that the system is in cooling mode.
1. From the home screen, press . The system setting menu
appears.
2. Press or to choose the desired system setting.
3. When the symbol for the desired setting appears, confirm
your choice by
• Pressing (the home screen will appear), or
• Pressing or (the next menu will appear), or
• Waiting 5 seconds.
Indicates that the system is in heating mode.
Indicates emergency heat. It is used by facility
operators or service technicians only.
Indicates that the system automatically switches
between heating and cooling as needed.
Indicates that the system is Off.
Changing Fan Settings
Indicates that the fan will operate as needed
to reach the selected temperature.
1. From the home screen, activate the fan setting menu by
pressing and then .
2. Press or to choose the desired fan setting.
3. When the symbol for the desired setting appears, confirm your
choice by pressing (the home screen will appear).
Indicates that the fan setting is On. The
number of arrows indicates fan speed

(3: high, 2: medium, 1: low).
The example shown indicates a fan on high
speed. Not all systems offer all three speeds.
Indicates fan is Off.
Requesting Temporary Occupancy
Select to request
occupancy
• If you need heating or cooling after normal business hours, you can “request”
temporary occupancy by pressing
and holding it for 2 seconds. The occupied
symbol remains on the screen and the unoccupied symbol disappears. After 30
seconds, the unoccupied symbol will re-appear. The system will remain in occupied
mode for a pre-determined period.
• To cancel temporary occupancy, press and hold for 2 seconds. The unoccupied
symbol will remain on the screen and the occupied symbol will disappear. After 30
seconds the occupied symbol will re-appear. (Cancellation can be made at any time
during the temporary occupancy period.)
Select to cancel
occupancy
Main processor error
Replace sensor.
Software version conflict
Replace sensor.
Communication error
Replace sensor.
Temperature input outside valid operating range
(32ºF–122ºF [0ºC–50ºC]) Replace sensor if space temperature is within valid range.
Error codes
Indicates that the keypad is locked
The lock symbol appears if you try to adjust a setting that cannot be changed.
Lock Symbol