Trane Technologies Thermo King T-1090 Series, Руководство оператора

Страница: 37 / 104

TK 56702-1-OP-EN 37
• If either the YES or NO key is not pressed within 10 seconds of making a
change with the + or - key, the setpoint is not changed, and the display
returns to the Setpoint Display. The display briefly shows [SETPOINT
NOT CHANGED] and Alarm Code 127 Setpoint Not Entered is set, to
indicate that a setpoint change was started but not completed.
Figure 30. Standard Display, New Setpoint
Starting the Diesel Engine
C CA AU UT TIIO ON N
R Riisskk o off IIn njju urry y!!
The engine may start automatically any time the unit is turned on.
N NO OT TIIC CE E
E Eq qu uiip pm me en ntt D Da am ma ag ge e!!
Never use starting fluid. Damage to the engine can occur.
Diesel engine preheats and starts are automatic in both Continuous Mode
and CYCLE-SENTRY Mode. The engine will preheat and start as required
when the unit is turned on. The engine preheat and start will be delayed in
CYCLE-SENTRY mode if there is no current need for the engine to run. If any
keys are being pressed on the HMI Control Panel, the engine will not preheat
and start until 10 seconds after the last key is pressed.
N No otte e:: If the unit is equipped with optional Electric Standby, there may be
some additional prompts before the engine will start. Refer to Starting
the Electric Motor for details.
When the engine is preparing to start, the HMI Control Panel will display the
engine start screen (
Figure 31, p. 38 ). The preheat buzzer sounds during the
engine preheat and crank sequence.
O Op pe erra attiin ng g IIn nssttrru uccttiio on nss ffo orr P Prre em miiu um m H HM MII C Co on nttrro oll P Pa an ne ell