16
TRAK Machine Tools
Southwestern Industries, Inc.
TRAK 3ntr 3D Printers
–
Maintenance & Troubleshooting Manual
16)
Plug in the PTFE piping, feed the filament.
17)
Check XY alignment.
See Section
XY Offset
for Procedure.
3.4
Filament Feeder Installation
This section details the process to install the filament feeders to the printer. Each feeder has a specific
position: refer to the illustrations applicable to your printer (below). If machine has three extruders, the
longest pipe must go on the #1 feeder (the right most one, when looking from rear side).
Figure 3.4.1 Two Nozzle Feeder (A4)
Figure 3.4.2 Three Nozzle Feeder (A2)
Figure 3.4.3 Two Nozzle Feeder (A2)
NOTE
–
Before fitting it on the printer, each filament feeder assembly must have its PTFE pipe fitted
