www.TrailFX.com
Page
6
of
8
Rev022818
8.
Attach the Running Board to the Brackets with (6) 8mm Flat Washers, (6) 8mm Lock Washers and (6) 8mm Hex Nuts,
(Figures 19 & 20)
.
NOTE
: The Running Board is designed to fit close to the vehicle. It may be necessary to loosen the
Bracket hardware and tilt the Brackets downward to insert the Running Board between the Brackets and the body. Do not
tighten hardware at this time.
9.
Properly level and adjust the Running Board and fully tighten all hardware.
NOTE
: Line up front of Running Board
approximately 2” back from front wheel opening.
2009-10 models requiring drilling for driver side Support Brackets
:
a.
Make sure the Running Board is level to the vehicle. Adjust and tighten all mounting hardware.
b.
Line up the slots on the Support Brackets with the back of the pinch weld. Mark the location of the slots onto the pinch
weld.
c.
Drill (2) 1/4” holes through the pinch weld for each Support Bracket.
IMPORTANT
: Do not drill too close to the bottom
edge of the pinch weld. Adjust the Brackets as necessary to move the slots up the body panel away from the edge.
Drill the holes toward the outside of the marked slots.
d.
Attach each Support Bracket to pinch weld with (2) 6mm Hex Bolts, (4) 6mm Flat Washers and (2) 6mm Nylon Lock
Nuts,
(Figures 12, 14, 17, 19 & 20)
. Check for level and fully tighten all hardware.
Front
(Fig 18) Slide the 8mm Double
Bolt Plate into channels
(2) 8mm Flat Washers
(2) 8mm Lock Washers
(2) 8mm Hex Nuts
Rear
(Fig 20) Driver/left rear Bracket assembly
(same as passenger/right front and center)
(Fig 19) Driver/left front Bracket assembly
Front
