www.TrailFX.com
Page
4
of
8
Rev022818
4.
Next, select the driver side front Support Bracket. Attach the Bracket to the front facing side of the front Bracket with (1)
8mm x 30mm Hex Bolt, (2) 8mm Flat Washers and (1) 8mm Nylon Lock Nut,
(Figure 10)
. Rotate the Support Bracket to
the back of the pinch weld. Line up the slots in the top of the Support Bracket with the (2) factory holes in the pinch weld.
Attach the Bracket to the back of the pinch weld with (2) 6mm x 25mm Hex Bolts, (4) 6mm Flat Washers and (2) 6mm Nylon
Lock Nuts,
(Figures 11 & 12)
. Do not fully tighten hardware at this time.
IMPORTANT
:
2009-10
models are not equipped
with factory holes and will require drilling through the pinch weld to attach the Support Bracket. Do not drill through pinch
weld at this time, (
see Step 9
).
(Fig 8) Driver side front mid 2015-on, an example of
models with factory installed threaded inserts
Front
(Fig 9) Driver side front models with factory
installed threaded inserts. Bolt Plate not required
Front
(2) 8mm Hex Bolts
(2) 8mm Lock Washers
(2) 8mm Flat Washers
(Fig 10) Attach Driver/Left front Support Bracket
to front facing side of Mounting Bracket
Front
8mm Hex Bolt
(2) 8mm Flat Washers
8mm Nylon Lock Nut
Front
(2) 6mm Hex Bolts
(4) 6mm Flat Washers
(2) 6mm Nylon Lock Nuts
(Fig 12) Driver side front Bracket assembly
8mm Hex Bolt
(2) 8mm Flat Washers
8mm Nylon Lock Nut
(Fig 11) Attach Support Bracket to back of pinch weld
(models with factory holes in pinch weld only)
Front
(2) 6mm Hex Bolts
(4) 6mm Flat Washers
(2) 6mm Nylon Lock Nuts
