www.TrailFX.com
Page
8
of
9
Rev 010115
21.
Reinstall the Brackets and Running Board as previously described.
22.
Bolt the front, center and rear Support Brackets to the holes drilled through the pinch weld,
(Step 19)
, with (5) 6mm x 25mm
Hex Bolts, (10) 6mm x 12mm Small Flat Washers and (5) 6mm Nylon Lock Nuts,
(Figure 19)
.
23.
Level and adjust the Running Board and tighten all hardware.
24.
Repeat
Steps 1
– 23
for passenger side Running Board installation.
(Fig 18B) Cut a slot the approximate width of the
Mounting Brackets. Do not cut through outer top
edge of cover
Front
Outsid
e
All Support Brackets to pinch weld use:
6mm x 20mm Hex Bolt
(2) 6mm x 12mm Small Flat Washers
6mm Nylon Lock Nut
Fig 19
Rear
(2) 6mm x 22 Large Flat Washers
(2) 6mm Lock Washers
(2) 6mm Hex Nuts
Complete Installation
