www.TrailFX.com
Page
6
of
9
Rev 010115
14.
Move to the rear Bracket assembly first. Tighten the hardware securing the Mounting Bracket to the floor panel,
(Figure 11)
.
Line up the Support Bracket with the outside of the pinch weld. Mark the location of the hole onto the pinch weld,
(Figure
14)
.
IMPORTANT
: Do not place a mark too close to the edge of the pinch weld. Note that the height of the rear Bracket
cannot be adjusted. Adjust the height of the front and center Brackets to match the rear Bracket to properly level the
Running Board.
15.
Move up to the front Bracket assembly. Tighten the 8mm hardware securing the Bracket to the bottom of the frame channel,
(Figure 4)
.
NOTE
: Use clamps to temporarily hold the front and center Support Brackets in position against the pinch weld
as you adjust the height of the Brackets,
(Figure 15)
. Note that if clamps are not available, use a jack, jack stands or blocks
to hold the front Brackets up and level with the vehicle.
(Fig 14) Rear Bracket marked before drilling
Front
(Fig 15) Use a clamp to hold the front and
center Brackets up to the pinch weld
Front
8mm x 30mm Hex Bolt
8mm Lock Washer
8mm Flat Washer
Fig 4
