www.TrailFX.com
Page
5
of
9
Rev 010115
11.
Select the driver side Rear Bracket. Attach the rear Bracket to the Bolt Plate with (1) 10mm Flat Washer, (1) 10mm Lock
Washer, (1) 10mm Hex Nut, (1) 12mm Flat Washer, (1) 12mm Lock Washer and (1) 12mm Hex Nut,
(Figure 11)
. Do not
fully tighten hardware at this time.
12.
Select the driver side Rear Support Bracket. Bolt the Support Bracket to the front of the rear Mounting Bracket and on the
outside of the pinch weld with (1) 8mm x 20mm Hex Bolt, (2) 8mm Flat Washers and (1) 8mm Nylon Lock Nut,
(Figure 12)
.
Leave hardware loose at this time.
13.
Carefully unwrap and select the driver side Running Board. Insert (6) 6mm T-Bolts into the slots in the ends of the channels,
(3 T-Bolts per slot), on the bottom of the Running Board,
(Figure 13)
. Hold the Running Board up in the approximate
position over the Brackets and slide the T-Bolts down the slots to line up with the Brackets. Tilt the Running Board up at a
slight angle to clear the slots in the Brackets. Secure the Running Board to the Brackets with (6) 6mm Flat Washers, (6)
6mm Lock Washers and (6) 6mm Hex Nuts,
(Figure 19)
.
NOTE
: The Running Board is designed to fit close to the vehicle. It
may be necessary to loosen the (3) Mounting Brackets and tilt the Brackets downward to insert the Running Board. Do not
fully tighten hardware at this time.
All Support Brackets to pinch weld use:
6mm x 20mm Hex Bolt
(2) 6mm x 12mm Small Flat Washers
6mm Nylon Lock Nut
Fig 19
Rear
(2) 6mm x 22 Large Flat Washers
(2) 6mm Lock Washers
(2) 6mm Hex Nuts
(Fig 13) Slide 6mm T-Bolts (3 per slot)
into slots on bottom of Running Board
(Fig 12) Bolt the driver side rear Support Bracket
to the front of the rear Bracket
Rear
8mm x 20mm Hex Bolt
(2) 8mm Flat Washers
8mm Nylon Lock Nut
12mm Flat Washer
12mm Lock Washer
12mm Hex Nut
10mm Flat Washer
10mm Lock Washer
10mm Hex Nut
Fig 11
Rear
