www.TrailFX.com
Page
1
of
6
Rev 070119
THE GRILLE GUARD MAY INTERFERE WITH PARKING SENSORS,
PROXIMITY SENSORS AND CRUISE CONTROL SENSORS.
REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT.
READ INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION.
DO NOT OVER
TORQUE
.
STANDARD OPERATING LOAD FOR TIGHTEN
BODY MOUNT NUTS & BOLTS VARIES FROM
45
TO
65
FOOT POUND.
60-180 min
1 866 638 4870
LIMITED 3-YEAR WARRANTY
Cutting May be
Required
PARTS LIST:
Qty
Part Description
Qty
Part Description
1 Driver/Left Fender Assembly
20 6-1.0mm x 25mm Button Head Bolts
1 Passenger/Right Fender Assembly
20 6 x 12mm x 1.6mm Flat Washers
1 6mm Threaded Insert Tool
20 6mm Lock Washers
14 6mm Threaded Inserts
6 6mm Flange Nuts
1 4mm Wrench
PROCEDURE:
REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS
CAREFULLY. CUTTING AND MODIFICATION IS REQUIRED TO REINSTALL THE PLASTIC FENDER
LINER. DRILLING IS REQUIRED. ASSISTANCE IS RECOMMENDED.
1.
Start installation on the passenger/right side of the vehicle. Release the plastic clips and remove any
hardware attaching the liner to the outer edge and underside of the fender and the body,
(Figure 1)
.
Remove the inner fender liner.
2.
Next, firmly pull the fender straight outward from the body to pop the clips from the mounting holes,
(Figure 2)
. Remove any clips left attached to the body panel and move the fender to a clean surface.
3.
Select the passenger/right Formed Rear Fender. Carefully place the Fender up to the mounting location
on the vehicle. Line up the holes in the Fender with the matching holes in the body to identify the correct
mounting holes required for installation,
(Figures 3 & 4)
. Mark the (7) mounting holes requiring drilling
REAR STEEL FENDER
Part No. JL05RF
Fits:
2018
+
JEEP Wrangler JL / JLU
Passenger/Right
Fender Assembly
Front
6mm Threaded Insert
Installation Tool
(14) 6mm Threaded Inserts
Driver/Left Fender
Assembly
Front
Drilling Is
Required
