www.TrailFX.com
Page
3
of
5
Rev 020218
6.
Remove bolts and swing outer bumper support tubes down and out of the way, using a 15mm socket. Two Bolts per side.
(Fig 4)
.
7.
Remove the dart clips holding the rubber valance between the frame and the bumper.
8.
Remove 21mm nuts(2 Per Side) from the bolt strips holding the bumper brackets to the frame.
NOTE: SUPPORT BUMPER BEFORE REMOVING BOLT STRIPS (Fig 5)!
.
9.
With the bumper supported remove the bolts strip holding the bumper to the frame.
10.
Pull outward slightly at the fender wells and remove from the front.
11.
With Bumper removed from the truck, remove the 18mm bolts attaching the Factory Tow Hooks to the frame. Remove the
tow hooks.
Bumper Installation
1.
Remove the fog light from the vehicle. Use the OEM screws and nut plates to fasten the fog light to the bumper
(Fig 6)
.
Fig 4
Fig 5
Fig
6
