www.TrailFX.com
Page
3
of
6
Rev 032618
g. Use the provided Wire Ties to secure the Wiring Harnesses to the back of the Bumper.
9.
If front license plate is required, attach the License Plate Bracket to the holes in the bumper with the included (2) 6mm x
20mm Button Head Bolts, (4) 6mm Flat Washers and (2) 6mm Nylon Lock Nuts,
(Figure 11)
. Insert (2) Plastic Plugs into
the square holes in the Bracket. Reuse the factory screws to attach the license plate to the plastic plugs.
10.
With assistance, position the LD1 Bumper Assembly up to the insides of the Frame Brackets. Temporarily support the
weight of the Bumper.
WARNING
: To avoid possible injury or damage to the vehicle, do not proceed until the Bumper is
fully and safely supported.
11.
Attach the Bumper to the inside of the Frame Brackets with (6) 12mm x 40mm Hex Bolts, (12) 12mm x 37mm Flat Washers
and (6) 12mm Nylon Lock Nuts,
(Figures 12 & 13)
. Do not fully tighten hardware.
12.
Reattach the main wiring harness to the bumper sensors, if equipped.
13.
Level and adjust the bumper and fully tighten all hardware.
14.
Trim off the underlined section of the plastic wheel well liner for a clean finish, optional. See
Figure 14
.
15.
Do periodic inspections to the installation to make sure that all hardware is secure and tight.
WARNING!
Do not remove bumper bolts
unless the bumper is properly supported on
blocks or stands or the bumper may fall.
(Fig 3) Temporarily remove plastic
grille to access top bumper bolts
(Fig 2) Open hood and remove plastic cover
Front
(Fig 1) Unplug lights and sensors if equipped.
Unplug harness to bumper and move harness
Front
Front
(Fig 4) Remove hex nuts from bumper bolts (arrows).
Bumper bracket pictured from below/behind bumper
