Page
4
of
5
5.
Starting at the bottom of the frame, tighten the lower 12mm Frame Bracket mounting hardware first then move to
the side of the frame. Fully tighten Frame Bracket to 12mm Bolt Plate hardware only at this time. Do not tighten the
10mm Bull Bar Bracket hardware.
6.
Repeat
Steps 1
—5
for passenger side Frame and Mounting Bracket installation.
7.
With assistance, position the Bull Bar assembly up to the inside of the Mounting Brackets. Attach the Bull Bar to
the Brackets with the included (4) 10mm x 30mm Hex Bolts, (8) 10mm Flat Washers and (4) 10mm Nylon Lock
Nuts,
(Figure 8)
. Do not fully tighten hardware at this time.
8.
Level and adjust the Bull Bar and fully tighten all remaining hardware.
9.
Do periodic inspections to the installation to make sure that all hardware is secure and tight.
(2) 10mm x 30mm Hex Bolts
(4) 10mm Flat Washers
(2) 10mm Nylon Lock Nuts
(Fig 7) Attach driver/left Bull Bar
Bracket to inside of Frame Bracket
(Fig 8) Attach Bull Bar to inside of Mounting Brackets
(2) 10mm x 30mm Hex Bolts
(4) 10mm Flat Washers
(2) 10mm Nylon Lock Nuts
