Page
2
of
5
INSTALLATION PROCEDURE:
CUTTING MAY BE REQUIRED. INSTALLATION MAY INTERFERE WITH BUMPER MOUNTED
PARKING SENSORS. ASSISTANCE IS RECOMMENDED.
NOTE:
It may be necessary to remove/relocate front license plate and license plate bracket. It is not
required, but strongly recommended. If local/state law requires a front license plate, license plate relocation
kit is available.
1.
Starting at the driver side, remove the factory tow hook if equipped,
(Figures 1A & 1B)
.
NOTE:
This Bull
Bar is not compatible with the factory tow hooks and they cannot be reinstalled.
IMPORTANT
: On some
model years, with and without tow hooks, the pocket in the plastic bumper may need to be trimmed or
completely cut out,
(Figure 1A)
. Use a sharp knife or hacksaw blade and carefully cut out the pocket to
clear the Bull Bar Brackets. Only cut enough to clear the Brackets.
2.
Insert (1) 12mm Bolt Plate,
(Figure 3)
, into the end of the frame channel,
(Figure 4)
, and out through
the hole in the bottom of the frame. Insert a second Bolt Plate into and out the hole in the outer side of
the frame, (factory hole for tow hook bolt),
(Figures 4 & 5)
. Thread 12mm Plastic Retainers onto the Bolt
Plates to help hold them in place as needed.
NOTE
: Plastic Retainers are not required for installation
and use is optional.
Front
Fig 1B) Remove the tow hook and hardware,
(Driver/left tow hook pictured from below bumper)
(Fig 3) 12mm Bolt Plate with hardware
(Fig 4) Driver/left side tow hook opening pictured
(2) 12mm Bolt Plates
Remove the factory tow
hook and hardware. Tow
hook will not be reinstalled
Fig 1A
