www.TrailFX.com
Page
6
of
8
Rev 091620
Driver Side Installation Pictured
Hold the splash guard up to the bottom of the
brackets and mark location for cutting to
clear brackets. Cut only what is needed to
insert bracket through the splash guard.
Measure the distance from the mounting point
for the splash guard to the bracket on the driver
and passenger side. Use this measurement as a
reference point to check location before cutting
the 1" wide x 4" long slot
Cut only what is needed to insert bracket
through the splash guard. Do not cut
through the front edge of the splash guard
Installation pictured without the
splash guard for illustration
Hole for mounting bolt
Front
Front
Front
Front
Fig 10
Fig 11
Fig 12
Fig 13
(2) 12mm x 35mm Hex Bolts
(4) 12mm Flat Washers
(2) 12mm Lock Washers
(2) 12mm Hex Nuts
Driver side Support Bracket in "no tow
hook-no bumper support" position
