www.TrailFX.com
Page
5
of
7
Rev 031318
6.
Move to the rear location,
(Figure 17)
. Repeat
Step 5
to install the rear Mounting Bracket,
(Figure 18)
.
7.
Select the driver/left Sidebar. Carefully position the Sidebar onto the (3) Mounting Brackets.
IMPORTANT
: Do not slide,
(front to back or rotate), the Sidebar on the Brackets or damage to the finish on the Sidebar may result. Attach the Sidebar
to the (3) Brackets with (6) 8mm Combination Hex Bolts,
(Figures 19
—21)
. Do not fully tighten at this time.
Front
(Fig 16) Attach Driver/Left Support Bracket
to back of Center Mounting Bracket
IMPORTANT: 2009-2012 models without holes
in pinch weld will require drilling 1/4” holes
through pinch weld to attach driver side front
support bracket. Do complete installation of
sidebars first, level sidebar before drilling
holes for support bracket.
(Fig 17) Driver/Left rear mounting location
Rear
(Fig 18) Driver/Left rear Mounting Bracket assembly
Rear
(Fig 19) Driver/Left front Mounting Brackets
Front
(2) 8mm Combo
Hex Bolts
(Fig 20) Driver/left center Bracket assembly
Rear
(2) 8mm Combo
Hex Bolts
