www.TrailFX.com
Page
4
of
6
Rev 031318
3.
Next, select the driver side front Support Bracket. Attach the Bracket to the front facing side of the front Bracket with (1)
8mm x 30mm Hex Bolt, (2) 8mm Flat Washers and (1) 8mm Nylon Lock Nut,
(Figure 11)
. Rotate the Support Bracket to
the back of the pinch weld. Line up the slots in the top of the Support Bracket with the (2) factory holes in the pinch
weld. Attach the Bracket to the back of the pinch weld with (2) 6mm x 25mm Hex Bolts, (4) 6mm Flat Washers and (2)
6mm Nylon Lock Nuts,
(Figures 12 & 13)
. Do not fully tighten hardware at this time.
IMPORTANT
: 2009-10 models are
not equipped with factory holes and will require drilling through the pinch weld to attach the Support Bracket. Do not drill
through pinch weld at this time, (
see Step 7
).
4.
Move along the side of the body panel to the rear mounting location at the back of the cab,
(Figure 14)
. Repeat the
appropriate
Step 3
to install the driver side rear Bracket,
(Figures 15 & 16)
.
IMPORTANT:
The front bracket is different
from the rear Mounting Bracket, (see illustration above-note direction of mounting plate). Select the driver side rear
Support Bracket. Repeat
Step 4
to attach the Support Bracket to the back of the rear bracket and holes, (if equipped),
in the pinch weld,
(Figures 16 & 18)
.
Front
(Fig 13) Driver side front Bracket assembly
(2) 6mm Hex Bolts
(4) 6mm Flat Washers
(2) 6mm Nylon Lock Nuts
(Fig 12) Attach Support Bracket to back of pinch
weld (models with factory holes in pinch weld only)
Front
(2) 6mm Hex Bolts
(4) 6mm Flat Washers
(2) 6mm Nylon Lock Nuts
(Fig 11) Attach Driver/Left front Support Bracket
to front facing side of Mounting Bracket
Front
8mm Hex Bolt
(2) 8mm Flat Washers
8mm Nylon Lock Nut
(Fig 14) Driver/Left rear mounting location
Rear
IMPORTANT: 2009-2012 models without holes
in pinch weld will require drilling 1/4” holes
through pinch weld to attach driver side front
support bracket. Do complete installation of
sidebars first, level sidebar before drilling
holes for support bracket.
Front
(Fig 15) Attach Driver/Left Support Bracket to
back of Center Mounting Bracket
