www.TrailFX.com
Page
3
of
6
Rev 022818
INSTALLATION PROCEDURE
1.
Start the installation under the driver side of the vehicle and remove the front, center and rear body mount bolts. Do not
remove bushings.
2.
Hang the driver side front, center and rear Mounting Brackets from the body mounts in the order pictured above using
the factory hex bolts,
(Figure 1)
. Do not tighten hardware at this time.
3.
Locate the two factory holes in the bottom of the frame towards the front of the vehicle. Insert (1) 10mm Nut Plate,
(Figure 2A)
, into the oval hole and line up the threaded nut with the forward round hole,
(Figure 2B)
.
NOTE
: Nut Plate
and Support Bracket are not required on 2011-12 25-3500 models.
(Fig 1) Driver side front mounting bracket pictured
Front
Factory Body
Mount Bolt
Fig 2A
Fig 2B
Front
Insert 10mm
Nut Plate here...
...line up Nut
Plate here
