www.TrailFX.com
Page 2 of 6 Rev122718
PROCEDURE:
REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ
INSTRUCTIONS CAREFULLY BEFORE STARTING INSTALLATION. ASSISTANCE IS
RECOMMENDED.
1.
Start the installation under the driver/left side of the vehicle. Locate the front body mount,
(Figure 1).
Remove the front body bolt.
2.
Select the Driver/left side Front Bracket,
(Figure 2)
. Line up the upper slot on the Bracket
with the body bolt hole. Reuse the factory body bolt to attach the Bracket to the top of the
body mount,
(Figure 2)
.
3.
Move to the center mounting location,
(Figure 3)
. Repeat
Steps 1 & 2
to install (1) Center
Support Bracket to the center body mount,
(Figure 4)
.
4.
Move to the rear mounting location,
(Figure 5)
. Repeat
Steps 1 & 2
to install the Rear
Mounting Bracket to the rear body mount,
(Figure 6)
.
5.
Carefully unwrap and select the Driver/left Sidebar. Use the illustration above to help identify
the correct Sidebar. With assistance, line up the front end of the tube with the front Bracket
slot,
(Figure 7)
. Use (1) 1/2” Hex Bolt, (1) 1/2” Lock Washer and (1) 1/2” Flat Washer to
attach the front end of the Sidebar tube to the Front Bracket,
(Figure 8)
. Snug but do not
tighten hardware at this time.
6.
Attach the Sidebar to the Center Support Bracket using (1) 8mm Combo Bolt,
(Figures 9 &
10)
. Do not tighten hardware at this time.
7.
Repeat
Step 5
to attach the rear end of the Sidebar to the Rear Bracket,
(Figures 11 & 12)
.
8.
Level and adjust the Sidebar as necessary and fully tighten all hardware.
9.
Repeat
Steps 1—8
for Passenger/right Sidebar installation.
10.
Do periodic inspections to the installation to make sure that all hardware is secure and tight.
To protect your investment
, wax this product after installing. Regular waxing is recommended to add a protective
layer over the finish. Do not use any type of polish or wax that may contain abrasives that could damage the finish. Mild
soap may be used also to clean the Sidebar.
Driver/left Side Installation Pictured
Reuse factory body bolt
(Fig 2) Driver/left side Front Mounting
Bracket attached to front body mount
Front
(Fig 1) Driver/left side front mounting location
Front
