Trail Tech 5401-00 Скачать руководство пользователя страница 1

010-ELV-150

TRAIL TECH KICKSTANDS

Tech Support:  360-687-4530

[email protected]

5401-00/5401-10  KICKSTAND INSTALLATION

07-08 KAWASAKI KX250F/450F

07-09 KAWASAKI KLX450

07-14 KAWASAKI KX250F

07-11 KAWASAKI KX450F

2007 Kawasaki KX450F Kickstand Installed

1.

 Remove stock foot-peg, foot-peg hardware, & 

foot-peg hanger from frame. 

2.

 Install provided Trail Tech foot-peg bracket, using 

the OEM fasteners. 

(Use thread locking compound on 

the pivot bolt to ensure it does not back out.)

3.

 Re install foot peg & foot-peg hardware following 

manufacturers recommended installation procedure. 

4.

 Remove the stock side panel fastener and insert 

through the provided spring hanger tab. (Fig 1)

Continued on other side >>

5.

 Re-install the side panel fastener, and tighten down 

hand tight to start.

Note: Do not tighten down to manufacturers torque 

specification until spring is hung. Failure to do so may 

cause your spring to bind or break during use!

6.

 Hook spring into spring hanger mounting tab shown 

in (Fig. 2)

7.

 Using safety glasses & a spring puller stretch the 

spring and latch it onto the stand arm mounting point.

(Fig. 2)

8.

 Tighten sub-frame fastener to manufacturers torque 

specification.

FIG. 1

FIG. 2

LIMITED  WARRANTY

TRAIL TECH INC. WARRANTS TRAIL TECH KICKSTAND PRODUCTS TO BE FREE 

FROM DEFECTS IN MATERIAL AND WORKMANSHIP UNDER NORMAL USE AND IF 

PROPERLY INSTALLED FOR A PERIOD OF SIX MONTHS FROM DATE OF PURCHASE.  

IF FOUND TO BE DEFECTIVE AS MENTIONED ABOVE, IT WILL BE REPLACED OR 

REPAIRED.  THIS SHALL CONSTITUTE THE SOLE REMEDY OF THE PURCHASER 

AND THE SOLE LIABILITY OF TRAIL TECH INC.  TO THE EXTENT PERMITTED BY 

LAW, THE FOREGOING IS EXCLUSIVE AND IN LIEU OF ALL OTHER WARRANTIES OR 

REPRESENTATIONS WHETHER EXPRESSED OR IMPLIED, INCLUDED ANY LIMITED 

WARRANTY OF MERCHANTABILITY OR FITNESS.  IN NO EVENT SHALL TRAIL TECH 

INC. BE LIABLE FOR SPECIAL OR CONSEQUENTIAL DAMAGES.

IMPORTANT:  WEAR EYE 

PROTECTION WHEN HANGING 

SPRINGS!

Note:

 After every ride it is important to check your kickstand 

thoroughly for the following:

• Loose or damaged bolts • Bent or damaged kickstand leg or 

bracket • Damaged spring

Damaged or broken parts can result in serious injury! If any part of 

your stand has become 

damaged do not ride the machine! Contact a factory trained 

technician or Trail Tech directly for service or repairs.

FIG. 3

Отзывы: