TU501-x
Short Guide TU501-x v4.2, May 2019, ©Trackunit 2019
15
Approvals and Certifications
FCC/IC part 15.19
Notice
This device complies with Part 15 of the FCC Rules and with Industry
Canada license-exempt RSS standard(s). Operation is subject to the
following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
IC RSS-GEN
Notice
Le présent appareil est conforme aux CNR d'Industrie Canada applicables
aux appareils radio exempts de licence. L'exploitation est autorisée aux
deux conditions suivantes: (1) l'appareil ne doit pas produire de brouillage,
et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique
subi, même si le brouillage est susceptible d'en compromettre le
fonctionnement.
FCC part 15.21
Notice
Changes or modifications made to this equipment not expressly approved
by Trackunit may void the FCC authorization to operate this equipment.
FCC/IC
Radiofrequency
radiation exposure
Information
This equipment complies with FCC/IC radiation exposure limits set forth for
an uncontrolled environment. This equipment may be installed and
operated with minimum distance of 5 cm between the radiator and your
body.
This transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter.
Environmental
compliance
IEC 61373 - EN/IEC 60068-2-1:2007 - Cold
IEC 61373 - EN/IEC 60068-2-2:2006 - Dry Heat
EN 50125-1 - EN/IEC 60068-2-27:2010 - Shock
SAE J1455 - EN/IEC 60068-2-31:2008 - Drop
EN 50125-1, SAE J1455 - EN/IEC 60068-2-64:2008 - Random vibration
IEC 61373 - EN/IEC 60068-2-78:2001 - Damp heat steady state
IEC 61373 - (IEC 60529+A1+A2) CSV:2013 - Degrees of protection (IP
code): IP67
NOTE A: The TU501 is not to be mounted in areas with presence of motor
oil, gasoline, diesel fuel, hydraulic fluid, brake fluid, transmission fluid,
glycol and water mixture, etc.
NOTE B: The housing is not designed to withstand high pressure cleaning.
Only use the TU501 when mounted inside the designated Trackunit
protection cap (7402.9551 Trackunit Raw hardware shield can be ordered
at Trackunit) in mounting areas where high pressure cleaning is common
procedure.
