Trackmaster TMX428, Руководство по обслуживанию

Страница: 38 / 159

Set-up Instructions Ch. 5 TRACKMASTER
36 TMX428 TMX428CP & TMX58 Service Manual 317-160-406 Rev 4
May 2021
WARNING
The TMX428 and TMX428CP conforms to FCC class B rating for electromagnetic
emissions. It is recommended not to place the treadmill closer than 5ft. (1.5m) from
sensitive electronic devices within the room or in an adjacent room. If an
interference problem occurs, move the treadmill farther away from the sensitive
device or relocate either device to another area, or consult with an EMI specialist
for ways to shield the room from electromagnetic radiation.
Do not place it on thick or long-pile carpeting. Such carpeting could cause
instability or static build-up, and carpet fibers could get caught in the belt and
damage the unit.
Ensure that power cords do not cross traffic areas. Exposed power cords can cause
a fall, resulting in injury.
Keep it away from sources of moisture, such as spas or fountains. Moisture can
cause the electronic circuitry to malfunction.
Final Setup - Running Belt Tracking Adjustment
The MasterTrack
®
Belt Tracking System significantly reduces the need to adjust the belt
on your treadmill. However, when you operate your treadmill for the first time, you may
need to adjust the tracking of the belt to conform to your floor. You may also need to
adjust the tracking if you move the machine to another location. See Preventative
Maintenance Chapter 7 for Running Belt Tracking Adjustment.
NOTE: Because this adjustment is not covered under your warranty, it is important that
you review these instructions thoroughly before proceeding. Uneven floors
accelerate belt misalignment. This situation may require more frequent
adjustments to prevent belt damage.
Final Setup - Running Belt Tension Adjustment
Your TRACKMASTER
®
running belt has been pre-tensioned at the factory and run for a
minimum of 16 hours prior to shipment. It may, however, be necessary to adjust the belt
tension when the treadmill is run in its final location. A loose belt tends to hesitate or stick
with a heavy foot plant. If your belt needs tensioning refer to Preventative Maintenance
Chapter 7 for Running Belt Tension Adjustment.
NOTE: Improper adjustment could cause the treadmill to hesitate and cause a trip and
fall hazard. Because this adjustment is not covered under your warranty, it is
important that you review these instructions thoroughly before proceeding.
Final Setup - Drive Belt Tension Adjustment
The drive belt tension has been set at the factory and is self-adjusting to minimize
maintenance. This design will compensate for initial stretch of the drive belt and not
require further adjustment. If the belt becomes stretched and loose, refer to Preventative
Maintenance Chapter 7 for Drive Belt Tension Adjustment.
NOTE: Because this adjustment is not covered under your warranty, it is important that
you review these instructions thoroughly before proceeding.