Tracker Off-Road 800SX, Руководство по обслуживанию, Страница: 46 / 192

44
Doors
ADJUSTING DOORS
1. Door adjustment is accomplished by loosening the
striker plate cap screws; then moving the striker
plate up, down, in or out on the slotted holes. When
desired latching/unlatching is obtained, tighten cap
screws.
MOD279
Roof (Optional)
REMOVING/INSTALLING
1. Remove the cap screws and lock nuts securing the
clamps at the rear of the roof. Account for the wash-
ers and the lock nuts. Discard lock nuts. Inspect cap
screws and replace if damaged.
MOD689
MOD690
2. Remove the cap screws and lock nuts at the front of
the roof. Account for the washers and the lock nuts.
Remove the roof. Discard lock nuts. Inspect cap
screws and replace if damaged.
MOD691
MOD692
3. Position roof onto the ROPS of the vehicle; then
hook the rear brackets under the rear ROPS tube;
then loosely secure the four rear brackets to the
rear of the hardtop using eight cap screws, eight
washers, and eight new lock nuts. The washers
should be on the top of the roof. Finger tighten
only at this time.
4. Loosely secure the front of the hardtop to the
ROPS using four cap screws, four washers, and
four new lock nuts. The washers should be on the
outside of the roof.
5.
Tighten all hardware securely.
Front Bumper (Optional)
REMOVING/INSTALLING
1. Remove the two cap screws and lock nuts per side on
the lower portion of the front bumper. Note the loca-
tion of the spacers. Discard lock nuts. Inspect cap
screws and replace if damaged.