Tracker Off-Road 800SX, Руководство по обслуживанию, Страница: 33 / 192

31
9. Install the wheels and using a crisscross pattern,
tighten the wheel nuts in 20 ft-lb (27.2 N-m) incre-
ments to a final torque of 100 ft-lb (136 N-m).
10. Remove the vehicle from the support stand.
Accelerator Pedal
REMOVING
Disconnect the connector from the accelerator pedal;
then remove the two lock nuts from the inner fender
securing the accelerator pedal assembly to the splash
panel and remove the accelerator pedal. Discard lock
nuts.
MOD534
MOD535
INSTALLING
Align the accelerator pedal studs with the holes in the
splash panel and secure with two new lock nuts from the
inner fender; then tighten to 8 ft-lb (10.9 N-m); then con-
nect the connector to the accelerator pedal.
MOD535
MOD534
Throttle Cable
This ROV/UTV is equipped with an Electronic Throttle
Control (ETC) that does not have a traditional cable to
control the throttle. The throttle is controlled by electrical
wires (see the Electrical System section).
Shift Lever
REMOVING
1. Remove the steering wheel.
2. Remove the lower and upper steering adjuster cap
screws; then remove steering adjuster. With a suit-
able strap secure the steering wheel tilt assembly up
and out of the way.
3. Remove the cap screw and lock nut securing the shift
cable to the shift lever. Discard lock nut. Inspect cap
screw and replace if damaged.
MOD305
4. Remove the two cap screws securing the adjuster
bracket to the bottom of the steering housing.