TR TR3X, Руководство пользователя, Страница: 13 / 16

9
Troubleshooting
Phenomena Analysis Solution
You cannot turn on the radio.
The battery may be installed incorrectly. Remove and reattach the battery.
The battery power may run out. Recharge or replace the battery.
The battery may suffer from poor contact caused by dirty
or damaged battery contacts.
Clean the battery contacts or replace the battery.
During receiving, the voice is
weak or intermittent.
The battery voltage may be low. Recharge or replace the battery.
The volume level may be low.
Rotate the On-Off/Volume Control knob to increase the volume,
or consult your dealer to disable the Digital Mic AGC feature.
The antenna may be loose or may be installed incorrectly. Turn the radio off, and then remove and reattach the antenna.
The speaker may be blocked. Clean the surface of the speaker.
You cannot communicate with
other group members.
The frequency or signaling type may be inconsistent with
that of other members.
Verify that your TX/RX frequency and signaling type are correct.
The channel type (digital or analog) may be set incorrectly. Verify that you are on the correct digital or analog channel.
You may be too far away from other members.
Stay close with other members.
The signal is poor. Make sure call participants are within the communication range.
You hear unknown voices or
noise.
You may be interrupted by radios using the same
frequency.
Change the frequency, or adjust the squelch level.
The radio may be set with no signaling.
Request your dealer to set signaling for all member radios to avoid