Printed in the Federal Republic of Germany
TR-Electronic GmbH 2010, All Rights Reserved
02/14/2018
TR - ECE - BA - DGB - 0075 - 06
Page 27 of 32
2.8 Personnel qualification; obligations
All work on the measuring system must only be carried out by qualified personnel.
Qualified personnel includes persons, who, through their training, experience and
instruction, as well as their knowledge of the relevant standards, provisions,
accident prevention regulations and operating conditions, have been authorized
by the persons responsible for the system to carry out the required work and are
able to recognize and avoid potential hazards.
The definition of “Qualified Personnel” also includes an understanding of the
standards VDE 0105-100 and IEC 364 (source: e.g. Beuth Verlag GmbH, VDE-
Verlag GmbH).
Define clear rules of responsibilities for the assembly, installation, start-up and
operation. The obligation exists to provide supervision for trainee personnel !
2.9 Safety information's
Destruction, damage or malfunctions of the measuring system and
risk of physical injury!
-
De-energize the system before carrying out wiring work or opening and
closing electrical connections.
-
Do not carry out welding if the measuring system has already been
wired up or is switched on.
-
Ensure that the area around the assembly site is protected from
corrosive media (acid, etc.).
-
Avoid any shocks (e.g. hammer-blow) on the shaft while mounting.
-
Do not open the measuring system.
The measuring system contains electrostatically endangered circuit
elements and units which can be destroyed by an improper use.
-
Contacts of the measuring system connection contacts with the fingers are to
be avoided, or the appropriate ESD protective measures are to be applied.
Disposal
If disposal has to be undertaken after the life span of the device, the respective
applicable country-specific regulations are to be observed.
