INTRODUCTION
INTRODUCTION
INTRODUCTION
INTRODUCTION
This note contains all the instructions and precautions for a safe set up and an optimal use of the product.
Warning: we are not responsible if any of these items below would not be respected and in this case, the TPL Vision’s
warranty shall not apply anymore to this product.
USER’S GUIDE
SCOA55 (High Power)
Rev A copyright TPL Vision ©
Rev A copyright TPL Vision ©
Rev A copyright TPL Vision ©
Rev A copyright TPL Vision ©
1/2
1/2
1/2
1/2
SET UP PROCEDURE
SET UP PROCEDURE
SET UP PROCEDURE
SET UP PROCEDURE
Lighting shall not be settled while the pro-
duct is powered on.
For the screws selection (not included) res-
pect the following indications :
Recommended torque: 0.5 to 1.5 Nm (Using
LOCTITE 243 (not supplied) is recommended)
PACKAGING /
PACKAGING /
PACKAGING /
PACKAGING / SHIPPING
SHIPPING
SHIPPING
SHIPPING /
/
/
/ RECEPTION
RECEPTION
RECEPTION
RECEPTION
The product is packaged in our factory using appropriate boxes and packages. They are made to avoid any damages by
means of regular transportation.
However a damaged parcel should be reported to the carrier upon receipt and stated officially at its reception (as a
"reserve"). Then, please report by writing to TPL VISION as soon as possible. (at least within 24 hours after the package
reception). Any package damaged during transportation will not be taken back or replaced if it has not been reported
on the travel voucher and to TPL VISION on time.
When you open the bag containing the product, any cutting blade should be avoided so as not to damage the product.
All accessories included in the package must be used if necessary (do not use other products or equivalent to replace
the accessories supplied).
SAFETY AND OPERATING INFORMATION
SAFETY AND OPERATING INFORMATION
SAFETY AND OPERATING INFORMATION
SAFETY AND OPERATING INFORMATION
Class III light
IP class of the product: see the product presentation
Operating temperature 0°C à 40°C
Power supply 24VDC+/- 10%, if this is not respected, you may damage the product and/or the user may be
electrocuted
Observe the power supply voltages and terminal plug in
Do not modify the product even partially
Do not clean while operating
Do not cover with a heat insulation or do not lock in a sealed area
Do not stare into the beam and follow the instructions below:
•
If possible set up a filter to block the product’s light radiation between the lighting product and the surrounding
worker
•
When the implementation of a filter is not possible, provide glasses or an adequate protection mask to workers in
order to block the light radiation
•
Forbid or limit as possible direct access to the light source (exposure in the axis of radiation)
•
Point out a security area to prevent workers from getting too close to the light; please follow the NZOR (Nominal
Zone of Optical Risk) recomandations given by TPL Vision (upon demand)
In any case, ensure that workers around the product are properly protected toward exposure
